Page 1 of 1

Victor 86B Issue

PostPosted: Mon Apr 11, 2016 12:33 pm
by Delghisallo
Hi,

I've just joined Too Much Coffee, so firstly hello!!

I have recently bought a Victor 86B to use in conjunction with my coretto and RoastLogger. All the instruction manuals are in Chinese so not sure if I'm doing something wrong, but when I connect the meter via USB to my laptop, the laptop recognises that a new device has been plugged in and on first plugging in it looked like a new driver was installed.

However when I try and connect through Roastlogger I am not getting any data transmitted (I have tried pressing the RS232 button). I also tried to connect and transmit data through the Victor software, but get an "open device failed" error.

I also tried the above on a second laptop and had the same issue.

I have tried to contact Victor but my email must be on the slow boast back to China, as I have not received a reply!

As anyone on the forum any ideas or experienced similar?

thanks in advance

Gareth

Re: Victor 86B Issue

PostPosted: Mon Apr 11, 2016 4:00 pm
by bruceb
Image

I still haven't bought a Victor yet so I can't help you, but perhaps GreenBean will show up and share some thoughts with you about the problem. Good luck and let us know how you get on.

Re: Victor 86B Issue

PostPosted: Tue Apr 12, 2016 10:33 am
by GreenBean
Hi Gareth, welcome to TMC :D I am sorry to hear about your problem with the Victor 86B multimeter. RoastLogger does not require any driver installed to communicate with the Victor 86B. Over the years a few users have been supplied with faulty meters. The fact that yours is not communicating with RoastLogger or the manufactures own software confirms that it is faulty. I suggest you contact the supplier rather than the manufacturer and request a replacement.

Re: Victor 86B Issue

PostPosted: Wed Apr 13, 2016 8:39 am
by Delghisallo
Thank you Bruce and Greenbean for your help

Gareth

Re: Victor 86B Issue

PostPosted: Thu Jun 22, 2017 2:04 pm
by jazzleg
Hello All,

I'm also new here. Recently started home roasting using Behmor 1600 Plus.

I recently purchased Victor 86B, but I also cannot to get it to work with RoastLogger. When I connected the multimeter via USB, it is displayed in Device Manager under category "Ports (COM & LPT)" and the name is "Silicon Labs CP210x USB to UART Bridge (COM3)". Is this normal?