Ive got a lovely little ECM raffaello A2 (not megaline) about 8 years old - the steam release valve stuck today (which it has done a bit recently) and of course the steam head on the boiler sprayed out lots of water inside the machine -Ive checked the cable between the PCB and the touch pad - all seems hunky-dory - the pcb is also not soaked - the trouble is, the touch pad is now completely unresponsive unless I switch the machine off and on again and then its only responsive for about 10 secs - this doesnt make drawing a shot impossible but i was wondering whether anyone had any ideas or whether theres a reboot possible of the PCB?
Ive tried reprogramming the touchpads after just switching the machine back on but it isnt held in the memory - PCBS are over 250 quid which is more than the machine cost so if anyone has a quick fix please let me know
Cheers