I just went through an episode of grinding a stone with my LSM FK and bought a new set of burrs.
Has anyone here ever installed a burr set on an LSM FK? Or a commercial conical grinder?
Specifically I'd like to know how to stop the lower burr from moving when loosening and tightening the center bolt?
And since there's little tolerance between the top and lower burr position, do you use a gauge to make sure it's centered or is the tolerance on the mounting holes tight enough so I don't need to worry about that?
Ideally I'd like to know before I install the new burrs it seems to be somewhat different than for flat burrs.
Thanks,
Wolf